Bores and Surfaces
Performance block machining Fixture
Head Surfacing Fixture
serial #1379 - 2006 model
Very nice condition
Located in Mansfield TX
go watch it run !!
220 volt 3 phase
35" length capacity
variable speed traverse hydraulic
x-y sweep adapter
New SG9MTS MANUALMATIC Touch Screen Control Seat & Guide Machine
The machine have 2 modes of operation:
MANUAL – the buttons on touch screen are the same as the previous SGM machines. There is no external dial gage, the spindle vertical position is displayed on the touch screen. Simply feed the spindle down until the cutting insert touches the valve seat, touch set zero button and then the digital display will show exactly where the spindle is at all times. The change from low to high/finishing speed is easier as there are 2 separate buttons. The foot pedal for clamp and float of workhead has been eliminated and now controlled on touch screen for manual and automatically for MANUALMATIC.
MANUALMATIC – a brand new concept has been added to these machines which should increase productivity by 30-50%. During seat cutting, the operator does not have to operate any buttons or switches, simply turn the spindle feed steering wheel up and down and the control takes care of all the functions like workhead float/clamp, pilot centering in the valve guide and spindle on/off. When depth of seat is reached, the control automatically changes spindle RPM to high/finish speed to give equal depth of every seat and consistent surface finish results.
The Rottler SG9MTS spindle is mounted on a sphere which allows the UNIPILOT to automatically center with the valve guide centerline while the Workhead is floating on air cushions. Once air floating stops and the Workhead clamps, the UNIPILOT and valve guide centerline are maintained while cutting the valve seat.
Gives Best Concentricity
Rottler's Rigid Precision carbide centering UNIPILOTS are manufactured to less than one tenth (.002mm) tolerance.
Combined with the light weight air float Workhead the SG9 gives perfect centering in the valve guide and the best concentricity of any machine on the market, .0005” per 1 inch of valve diameter (.01mm per 25mm Dia.).
Standard Equipment Includes: